Dodge Intrepid Service Manual page 803

23 - 66 INTERIOR
CENTER CONSOLE
CUPHOLDER ASSEMBLY
REMOVAL - CONCORD
(1) Remove shift knob.
(2) Remove floor console shift bezel (Fig. 7).
(3) Raise console armrest lid.
(4) Remove screws at top and bottom of cup
attaching assembly (Fig. 11).
(5) Lift up and forward to remove assembly.
Fig. 11 FLOOR CONSOLE CUP HOLDER ASSEMBLY
1 - SCREWS
2 - ARMREST LID
3 - SCREW HOLES
INSTALLATION
(1) Place cup attaching into floor console and align
screw holes.
(2) Install upper and lower screws.
(3) Lower console armrest lid.
(4) Install floor console shift bezel.
(5) Install shift knob.
CENTER CONSOLE LID LATCH
REMOVAL
(1) Open armrest lid.
(2) Remove latch attaching screws.
(3) Remove latch from console.
INSTALLATION
(1) Place latch in position.
(2) Install screws attaching latch to console.
(3) Check operation of latch.
CENTER CONSOLE REAR
BEZEL
REMOVAL
(1) Disengage tabs on sides at bottom (Fig. 12)
(2) Open arm rest lid and remove rear end cap
attaching screws.
(3) Remove rear bezel.
Fig. 12 FLOOR CONSOLE END CAP
1 - FASTENERS
2 - LOCATOR PINS
3 - TABS
INSTALLATION
(1) Align rear end cap in position on console.
(2) Install rear end cap attaching screws.
(3) Push forward at the bottom to lock tabs in
position.
CENTER CONSOLE SIDE
PANELS
REMOVAL
REMOVAL - CONCORD
(1) Remove shift knob.
(2) Remove floor console shift bezel (Fig. 7).
(3) For right side panel , open the glove box door
and remove side panel screws
(4) For left side panel, remove steering column
cover and side panel screws.
(5) Disengage clips from floor console.
(6) Remove floor console side panel(s).
LH