Dodge Intrepid Service Manual page 844

LH
HOUSING DRAIN HOSE (Continued)
Fig. 7 FRONT RIGHT
1 - DRAIN HOSE
2 - A-PILLAR
3 - GROMMET
REAR HOUSING HOSE
(1) Move glass panel to the fully closed position.
(2) Disconnect the control switch and wire connector.
1 - DRAIN HOSE
2 - HOSE FASTENERS
(3) Remove headliner as necessary (Refer to 23 -
BODY/INTERIOR/HEADLINER - REMOVAL).
(4) Remove rear shelf panel (Refer to 23 - BODY/IN-
TERIOR/REAR SHELF TRIM PANEL - REMOVAL).
(5) Disconnect the end of the drain tube from the
rubber grommet at the end of the drain tube closest
to the rear window of the vehicle (Fig. 8).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Disconnect the top end of the drain hose from
the sunroof housing drain nipple.
(8) Remove drain hose clips from the body holes.
INSTALLATION
FRONT HOSES
(1) Insert end of new hose into drain grommet and
replace grommet into sheet metal (Fig. 6) and/or (Fig. 7).
(2) Attach hose upper clips into holes in sheet
metal.
(3) Engage upper flair end of hose into sunroof
module drain nipple and secure with ratchet clamp.
REAR HOUSING HOSE
(1) Using the proper drain hose (there is a right
and left side rear hose) attach drain hose clips to
body holes, with the flair at the top towards the sun-
roof nipple.
(2) Connect top flair end of the drain hose to the
sunroof housing drain nipple with the ratchet clamp
(Fig. 8).
Fig. 8 REAR DRAIN HOSE
3 - DRAIN GROMMET
SUNROOF 23 - 107