Dodge Intrepid Service Manual page 786

LH
INSTRUMENT PANEL ASSEMBLY (Continued)
(20) Place the right console side cover into position
and firmly snap into place. Install the two screws to
right console side cover.
(21) Raise glove box door to by pinching sides
together, towards each other.
(22) Place the left console side cover into position
and firmly snap into place. Install the two screws to
the left console side cover.
(23) Connect wire connectors to HVAC control and
traction control switch.
(24) On five passenger vehicles, place instrument
panel center bezel into position and firmly snap into
place (Refer to 23 - BODY/INSTRUMENT PANEL/
STORAGE BIN - INSTALLATION).
(25) On six passenger vehicles, install the lower
floor bin (Refer to 23 - BODY/INSTRUMENT PAN-
EL/STORAGE BIN - INSTALLATION).
(26) Connect decklid release switch wiring connec-
tor, install the cable to brake release handle. Place
INSTRUMENT PANEL 23 - 49
the left lower instrument panel cover into position
and firmly snap into place. Install the two screws to
the lower instrument panel cover (outside end).
(27) Connect two wire connectors and one illumi-
nation bulb socket.
(28) Place shifter bezel into position and firmly
snap into place.
NOTE: On 300M vehicles, the shifter bezel must be
installed prior to the center bezel being installed.
(29) Install left and right instrument panel end
covers by placing into position and firmly snapping
into place.
(30) Install the one Allen screw to shifter knob.
(31) Connect the negative battery cable remote ter-
minal to the remote battery post (Fig. 1).