Dodge Intrepid Service Manual page 494

LH
COLUMN (Continued)
Fig. 15 Lower Shroud Attaching Screws
1 - LOWER SHROUD
2 - MOUNTING SCREWS
Fig. 16 Wiring Harness Connection To Clock Spring
1 - WIRING HARNESS CONNECTORS
2 - CLOCKSPRING
(22) Remove the two screws (Fig. 17) mounting the
clockspring to the steering column. Remove the clock-
spring from the steering column.
(23) Disconnect the wire harness connector at the
SKIM module. Remove the mounting screw and
unclip the module from the key cylinder halo bezel.
Fig. 17 Clockspring Location
1 - CLOCKSPRING
2 - MOUNTING SCREWS
(24) Remove the wiring harness from the routing
clip on the top of the multi-function switch. Remove
the 2 screws (Fig. 18) mounting the multi-function
switch to the steering column. Remove the multi-
function switch, with the wiring harness attached,
from the steering column.
Fig. 18 Multi-Function Switch
1 - MULTIFUNCTION SWITCH
2 - MOUNTING SCREW
3 - WIRING HARNESS
4 - STEERING COLUMN
5 - MOUNTING SCREW
COLUMN 19 - 17