Rear Seat Cushion - Dodge Intrepid Service Manual

LH
REAR SEAT BACK (Continued)
INSTALLATION - 60/40 SEAT COLLAR
ASSEMBLY
(1) Install the 60 seat section from the rear seat
back collar assembly.
(2) Install the 40 seat section from the rear seat
back collar assembly.
(3) Place the rear seat back collar assembly in
position in vehicle.
(4) Install nuts and bolts attaching rear seat back
collar assembly. Tighten nuts and bolts to 40 N·m (29
ft. lbs.) torque.
(5) Install the rear seat cushion (Refer to 23 -
BODY/SEATS/SEAT CUSHION REAR - INSTALLA-
TION).
REAR SEAT BACK COVER
REMOVAL
(1) Remove rear seat back (Refer to 23 - BODY/
SEATS/REAR SEAT BACK - REMOVAL).
(2) Pull cover over edges of the foam.
(3) Cut hog rings to free cover.
(4) Remove rear seat back cover from seat back.
INSTALLATION
(1) Position seat back cover on seat back.
(2) Install hog ring on right side listing pocket of
cover to foam, starting in the middle and lining up
the die cuts in the listing pocket with the hog ring
windows in the foam (three places).
(3) Repeat for the left side listing pocket of cover.
(4) Place cover seams in salvage trenches of foam.
(5) Roll corners and edges of cover over foam.
(6) Flip seat over making sure cover is pulled up
over frame on all corners. Push top, bottom, inside,
outside, corners of the foam into the cover and
engage J-strap retainers.
(7) Install rear seat back (Refer to 23 - BODY/
SEATS/REAR SEAT BACK - INSTALLATION).

REAR SEAT CUSHION

REMOVAL
(1) Pull upward at forward edge of cushion each
retainer loop of the rear seat cushion to disengage
retainer loops from cups in floor (Fig. 41).
(2) Remove rear seat cushion from vehicle.
INSTALLATION
(1) Place rear seat cushion in position.
(2) Engage retainer loops into cup on floor kick up.
(3) Push downward at forward edge at each
retainer loop of the rear seat cushion to engage
retainers.
Fig. 41 REAR SEAT CUSHION
1 - RETAINER LOOP
2 - REAR SEAT BACK
3 - REAR SEAT CUSHION
4 - CUPS
REAR SEAT CUSHION COVER
REMOVAL
(1) Remove rear seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION REAR - REMOVAL).
(2) Disengage the J-strap retainers (Fig. 42).
(3) Cut hog rings to free cover (Fig. 43).
(4) Remove seat cushion cover from seat cushion.
Fig. 42 REAR SEAT CUSHION COVER J-STRAPS
1 - J-STRAPS
INSTALLATION
(1) Position seat cushion cover on cushion.
(2) Install hog rings to seat cover.
(3) Engage the J-strap retainers.
(4) Steam wrinkles from seat cushion, if necessary.
SEATS 23 - 95