Dodge Intrepid Service Manual page 663

21 - 116 TRANSAXLE
INPUT CLUTCH ASSEMBLY (Continued)
(5) Install the input hub/shaft assembly. to the
OD/Reverse piston/clutch retainer ashy. (Fig. 294).
Fig. 294 Install Input Shaft Hub Assembly
1 - PUSH DOWN TO INSTALL INPUT SHAFT HUB ASSEMBLY
(ROTATE TO ALIGN SPLINES)
2 - OD/REV. PISTON
(6) Install input hub tapered snap ring (Fig. 295).
Make sure snap ring is fully seated.
Fig. 295 Install Input Hub Tapered Snap Ring
1 - INPUT SHAFT
2 - INPUT HUB SNAP RING (TAPERED SIDE UP WITH TABS IN
CAVITY)
3 - SNAP RING PLIERS
(7) Install UD clutch piston (Fig. 296).
Fig. 296 Underdrive Clutch Piston
1 - PISTON
(8) Install UD piston return spring and Tool 5067
as shown in (Fig. 297).
Fig. 297 Seal Compressor Special Tool 5067
1 - PISTON RETURN SPRING
2 - SPECIAL TOOL 5067
3 - INPUT CLUTCH RETAINER
LH