Dodge Intrepid Service Manual page 770

LH
WINDOW REGULATOR
REMOVAL
(1) Remove flag cover, door trim panel, water
shield as necessary, and pull cup support bracket.
(Refer to 23 - BODY/DOORS - REAR/TRIM PANEL -
REMOVAL)
(2) Slide glass from regulator roller channel (Fig.
12).
(3) Disconnect power window motor wire connec-
tor.
(4) Loosen screw attaching regulator scissor chan-
nel to door panel.
(5) Remove screw and bolt heads from keyhole
slots in door panel.
(6) Loosen bolt attaching regulator support brace
to door panel.
(7) Loosen bolts attaching regulator to door panel.
(8) Remove regulator from door panel.
(9) Slide regulator rearward and rotate forward
end of roller channel through access hole in door
panel.
INSTALLATION
(1) Insert roller channel through access hole in
door panel.
(2) Insert bolt and screw heads through key hole
slots in door panel.
(3) Tighten bolts attaching regulator to door panel.
(4) Tighten bolt to attach regulator support brace
to door panel.
(5) Tighten screw to attach regulator scissor chan-
nel to door panel.
Fig. 12 REAR DOOR WINDOW REGULATOR
1 - GLASS
2 - LIFT PLATES
3 - GLASS ROLLER CHANNEL
4 - WINDOW REGULATOR
5 - REAR DOOR
(6) Connect power window motor wire connector.
(7) Lower door glass on to regulator roller channel.
(8) Align glass and verify operation.
(9) Install pull cup support bracket, water shield,
door trim panel and flag cover.
DOORS - REAR 23 - 33