Tie Rod - Inner; Removal - Inner Tie Rod - Dodge Intrepid Service Manual

19 - 42 GEAR
SPEED PROPORTIONAL STEERING SOLENOID (Continued)
(6) Connect the wiring harness connector. Be sure
the wiring harness connector seal is in good
condition before installing the connector in the
control module.
(7) Road test vehicle, referring to the test indi-
cated in the Appropriate Diagnostic Information, to
confirm correct operation of the variable-assist speed-
proportional power steering gear.

TIE ROD - INNER

REMOVAL - INNER TIE ROD

(1) Remove the battery ground cable from the
ground stud on the shock tower and isolate the
ground cable by installing the cable isolator on the
ground stud (Fig. 33).
Fig. 33 Correctly Isolated Remote Ground Cable
1 - CABLE ISOLATOR
2 - GROUND STUD
3 - GROUND CABLE
(2) Remove caps from both wiper arms at the
attachment to the pivots to expose the wiper arm
attaching nut. Remove the nut attaching each wiper
arm to its pivot (Fig. 34).
(3) Remove the wiper arms from the pivots. Wiper
arms are removed from the pivots by rocking them
back and force on the pivots until they can be pulled
off the pivots.
(4) Remove the wiper module cover and cowl cover
from the vehicle (Fig. 35).
(5) Remove the 8 bolts attaching the reinforcement
to the strut towers and the 1 bolt attaching the wiper
module to the reinforcement (Fig. 36). Remove the
reinforcement from the vehicle.
(6) Remove the in-line resonator and inlet hose
from the throttle body and air let hose coming from
the lid of the air cleaner housing (Fig. 37).
Fig. 34 Wiper Arm Attachment To Pivot
1 - WIPER ARMS
2 - ATTACHING NUT
3 - ATTACHING NUT
Fig. 35 Wiper Module And Cowl Cover
1 - COWL COVER
2 - WIPER MODULE COVER
Fig. 36 Reinforcement Attachment To Vehicle
1 - RIGHT STRUT TOWER
2 - WIPER MODULE
3 - LEFT STRUT TOWER
4 - ATTACHING BOLTS
5 - ATTACHING BOLT
6 - REINFORCEMENT
7 - ATTACHING BOLTS
(7) Raise the vehicle on a frame contact hoist until
the front tires of the vehicle are just off the floor. See
Hoisting in Lubrication And Maintenance.
(8) Remove front wheel and tire assembly from
side requiring repair.
LH