Dodge Intrepid Service Manual page 762

LH
TRIM PANEL (Continued)
Fig. 14 INNER FRONT DOOR TRIM PANEL -
1 - POWER MIRROR SW.
2 - POWER DOOR LOCK SWITCH
3 - RETAINER CLIPS
4 - COURTESY LAMP
5 - POWER WINDOW SWITCH
INSTALLATION
(1) Place door trim panel in position.
(2) Install wire harness clips into door trim panel.
(3) Connect the courtesy lamp, if equipped.
(4) Connect the radio speaker wire connector.
(5) Connect the power window switch wire connector.
(6) Connect the power door lock switch wire con-
nector.
(7) Connect the power mirror switch wire connector.
(8) Connect the linkage to the handle assembly.
(9) Hook door trim panel over the sheet metal
flange.
(10) Insert the forward four way alignment guide
into position. Insert the rearward two way alignment
guide into position.
(11) Engage rear retaining clips to attach door
trim panel to inner sheet metal panel, up to three
ratchet clicks.
(12) Install three screws in the speaker area.
(13) Install two screws in the instrument panel
interface area.
(14) Install screw in the remote bezel, and close
trim plug.
(15) Install screw in pull cup, and close trim plug.
TYPICAL
(16) Install three screws to the bottom of the door.
Tighten all screws to 1.3 to 1.9 N·m (12 to 17 in. lbs.)
torque.
(17) Place speaker grille in position on trim panel.
TRIM PANEL - WOOD TRIM
REMOVAL - WOOD TRIM
(1) Remove door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Remove and discard the retainer clips (Fig. 15)
(3) Remove the wood trim from the trim panel.
(Fig. 16)
Fig. 15 WOOD TRIM CLIPS - TYPICAL
1 - RETAINER CLIPS
2 - TRIM PANEL
INSTALLATION - WOOD TRIM
(1) Install wood trim into mounting hole of the
trim panel (Fig. 16).
(2) Install new retainer clips and seat fully (Fig. 15).
(3) Install the door trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - INSTALLA-
TION)
DOOR - FRONT 23 - 25