Rear View Mirror - Dodge Intrepid Service Manual

23 - 72 INTERIOR
LOWER QUARTER TRIM (Continued)
INSTALLATION
(1) Place quarter trim in position on vehicle.
(2) Engage clips attaching lower quarter trim to
inner quarter panel.
(3) Install upper quarter trim.
(4) Install sill trim.
(5) Install rear seat cushion and back.
REAR SHELF TRIM PANEL
REMOVAL
(1) Remove seat cushion and back.
(2) Remove quarter trim lower and upper trim
panels.
(3) Remove center seat belt anchor bolt.
(4) Remove push pin fasteners.
(5) Pull rear shelf trim panel away from rear glass
to disengage clips (Fig. 22).
(6) Disengage CHMSL wire connector, if equipped.
(7) Feed center seat belt and bezel through rear
shelf trim panel
(8) Remove rear shelf trim panel from vehicle.
Fig. 22 PARCEL SHELF TRIM PANEL
1 - REAR SHELF TRIM
2 - PUSH PIN FASTENER
3 - CLIP LOCATION
INSTALLATION
(1) Place rear shelf trim panel in position in vehi-
cle.
(2) Feed center seat belt and bezel through rear
trim panel.
(3) Connect CHMSL wire connector.
(4) Push parcel shelf trim rearward toward rear
glass and engage clips.
(5) Insert push pin fasteners into position.
(6) Install quarter trim lower and upper panels.
(7) Install center seat belt anchor bolt. Tighten to
40 N·m (29 ft. lbs.) torque.
(8) Install seat back and cushion.

REAR VIEW MIRROR

REMOVAL
(1) If equipped, disconnect mirror harness connec-
tor.
(2) Loosen the mirror base setscrew (Fig. 23).
(3) Slide the mirror base upward and off the
bracket.
Fig. 23 REAR VIEW MIRROR
1 - CONNECTOR
2 - SCREW
3 - REAR VIEW MIRROR
4 - SUPPORT BUTTON
5 - WINDSHIELD
INSTALLATION
INSTALLATION
(1) Position the mirror base at the bracket and
slide it downward onto the support bracket (Fig. 23).
(2) Tighten the setscrew 1 N·m (15 in. lbs.) torque.
(3) If equipped, connect mirror harness connector.
INSTALLATION - REARVIEW MIRROR
SUPPORT BRACKET
(1) Mark the position for the mirror bracket on the
outside of the windshield glass with a wax pencil.
(2) Clean the bracket contact area on the glass.
Use a mild powdered cleanser on a cloth saturated
with isopropyl (rubbing) alcohol. Finally, clean the
glass with a paper towel dampened with alcohol.
(3) Sand the surface on the support bracket with
fine grit-sandpaper. Wipe the bracket surface clean
with a paper towel.
LH