Assembly - Dodge Intrepid Service Manual

21 - 28 TRANSAXLE
42LE AUTOMATIC TRANSAXLE (Continued)
(56) Remove low/reverse piston retainer screws
(Fig. 75).
Fig. 75 Remove Piston Retainer-to-Case Screws
1 - LOW/REVERSE CLUTCH PISTON RETAINER
2 - SCREWDRIVER
3 - TORX-LOC SCREWS
(57) Remove low/reverse piston retainer (Fig. 76).
Fig. 76 Remove Piston Retainer
1 - LOW/REVERSE CLUTCH PISTON RETAINER
2 - GASKET
(58) Remove low/reverse piston retainer gasket
(Fig. 77).
Fig. 77 Remove Piston Retainer Gasket
1 - GASKET HOLES MUST LINE UP
2 - LOW/REVERSE CLUTCH PISTON RETAINER GASKET

ASSEMBLY

NOTE: If the transaxle assembly is being recondi-
tioned (clutch/seal replacement) or replaced, it is
necessary to perform the Quick Learn Procedure
using the DRBIII Scan Tool (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL
MISSION CONTROL
PROCEDURE).
(1) Install the output bearing cups, use Special
Tool # 5050A (Fig. 78).
Fig. 78 Bearing Cup Installation Special Tool 5050A
MODULES/TRANS-
MODULE - STANDARD
LH