Dodge Intrepid Service Manual page 794

LH
UPPER RIGHT TRIM BEZEL(300M) (Continued)
INSTALLATION
(1) Position upper right trim bezel over slots in
instrument panel and firmly snap into place. If
equipped with traction control, connect connector.
(2) Tighten the lower right edge of steering column
cover, then tighten upper right corner of steering col-
umn cover.
(3) Install the one screw in center bezel area.
(4) Install the four screws along bottom edge of
trim bezel and close glove box.
(5) Position center instrument panel bezel over
slots and firmly snap into place.
(6) Connect the negative battery cable remote ter-
minal to the remote battery post (Fig. 1).
STORAGE BIN - 5 PASSENGER
VEHICLES
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 1).
(2) Remove ash receiver (if applicable).
(3) Using a trim stick (special tool #C-4755), gently
pry out on center trim bezel. Disconnect wiring con-
nectors to HVAC controls, cigar lighter/auxiliary
power outlet and
equipped).
(4) Remove instrument panel center trim bezel.
(5) Remove two retaining screws to the storage bin
and remove.
INSTALLATION
(1) Install the two retaining screws to the storage
bin.
(2) Install the instrument panel center trim bezel.
(3) Connect wiring connectors to HVAC controls,
cigar lighter/auxiliary power outlet and traction con-
trol switch (if equipped).
(4) Firmly snap the center trim bezel into place.
(5) Install the ash receiver (if applicable).
(6) Connect the negative battery cable remote ter-
minal to the remote battery post (Fig. 1).
STORAGE BIN - 6 PASSENGER
VEHICLES
REMOVAL
(1) Remove one screw and one push pin to the
lower instrument panel (Fig. 13).
(2) Pull rearward and remove the floor bin.
traction control switch
Fig. 13 CENTER FLOOR BIN
1 - INSTRUMENT PANEL
2 - INSTRUMENT PANEL FLOOR BIN
INSTALLATION
(1) Place the instrument panel bin into position
and firmly snap into place.
(2) Install one screw and one push pin to the lower
instrument panel.
STEERING COLUMN COVER
REMOVAL
(if
(1) Remove the left end cover.
(2) Remove two screws attaching steering column
cover (Fig. 14).
(3) Pull rearward on steering column cover to
release the retaining clips on the top and right edge.
Fig. 14 STEERING COLUMN COVER
1 - INSTRUMENT PANEL
2 - STEERING COLUMN COVER
INSTRUMENT PANEL 23 - 57