Installation; Front Fascia Removal Removal; Removal - Intrepid; Installation Installation - Dodge Intrepid Service Manual

13 - 2 FRAME & BUMPERS
FRONT FASCIA
REMOVAL
REMOVAL
(1) Release hood latch and open hood.
(2) Remove large rubber grommet (70 mm x 168
mm) from splash shield to gain access to fascia fas-
teners (Fig. 2).
(3) Remove fasteners attaching fascia to the front
fender and splash shield.
(4) Remove the nuts on the fascia studs through
the splash shield access holes on each side (Fig. 3).
(5) Remove the fasteners attaching the fascia to
the lower crossmember (Fig. 4).
(6) Remove the fasteners attaching the fascia to
the upper radiator closure panel (Fig. 4).
(7) Disconnect wire connectors (fog lamps, parking/
turn signal, side marker), if equipped (Fig. 5).
(8) Remove fascia from vehicle.
Fig. 2 ACCESS RUBBER GROMMET
1 - ACCESS RUBBER GROMMET

REMOVAL - INTREPID

(1) Release hood latch and open hood.
(2) Remove push pin fasteners attaching bottom of
fascia (air dam) to lower crossmember (Fig. 6).
(3) Remove fasteners attaching fascia to splash
shields (Fig. 7).
(4) Remove push pin fasteners attaching the fascia
to upper radiator closure panel.
(5) Pull the sides of the fascia outwards to disen-
gage fascia from drive pins then pull fascia forward.
(6) Disconnect fog
equipped.
lamp wire connectors,
Fig. 3 FASTENER LOCATIONS
1 - THROUGH ACCESS REMOVE FASTENER
2 - FASTENERS
Fig. 4 REMOVE PUSH PIN FASTENERS
1 - PUSH PIN FASTENERS
(7) Remove fascia from vehicle.

INSTALLATION

INSTALLATION
(1) Connect wire connectors.
(2) Place fascia in position on vehicle, by fitting
foam to bumper reinforcement. Use care not to
scratch fender. Tape may be put on fender for protec-
tion.
(3) Install the top center fasteners, to upper radi-
ator closure panel.
(4) Align fascia to bumper reinforcement.
(5) Align the two fascia studs to the fender vertical
attachments, at the same time align the fascia groove
on the horizontal flange with the fender fasteners.
Push fascia rearward to engage the fasteners.
if
LH