Dodge Intrepid Service Manual page 709

21 - 162 TRANSAXLE
VALVE BODY (Continued)
(15) Remove regulator valve spring retainer (Fig.
429).
Fig. 429 Remove Regulator Valve Spring Retainer
using Tool 6302
1 - TOOL 6302
2 - RETAINER
(16) Remove remaining retainers as shown in (Fig.
430).
Fig. 430 Valve Retainer Location
1 - RETAINER
2 - RETAINER
(17) Remove valves and springs as shown in (Fig.
431).
(18) Cleanliness through entire disassembly and
assembly of the valve body cannot be overempha-
sized. When disassembling, each part should be
washed in a suitable solvent, then dried by com-
pressed air. Do not wipe parts with shop towels.
All mating surfaces in the valve body are accurately
machined; therefore, careful handling of all parts
must be exercised to avoid nicks or burrs.
ASSEMBLY
NOTE: If the valve body assembly is being recondi-
tioned or replaced, it is necessary to perform the
Quick Learn Procedure using the DRBIII
Tool. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/POWERTRAIN CONTROL MODULE
- STANDARD PROCEDURE)
(1) Install valves and springs as shown in (Fig.
432).
LH
Scan