Dodge Intrepid Service Manual page 662

LH
INPUT CLUTCH ASSEMBLY (Continued)
(2) Install input shaft snap ring (Fig. 290).
Fig. 290 Install Input Shaft Snap Ring
1 - INPUT SHAFT
2 - SCREWDRIVER (DO NOT SCRATCH BEARING SURFACE)
3 - SNAP RING
4 - O-RINGS
5 - SEALS
(3) Using an arbor press and Tool 6057, Install
OD/Reverse piston return spring and snap ring (Fig.
291) (Fig. 292).
Fig. 291 Return Spring and Snap Ring
1 - OD/REVERSE PISTON
2 - RETURN SPRING
3 - SNAP RING
4 - O-RING
Fig. 292 Install Snap Ring
1 - ARBOR PRESS RAM (COMPRESS RETURN SPRING JUST
ENOUGH TO REMOVE OR INSTALL SNAP RING)
2 - SCREWDRIVER
3 - SNAP RING
4 - SPECIAL TOOL 6057
5 - OD/REVERSE PISTON
6 - RETURN SPRING
(4) Install the OD/Reverse piston assembly to the
input clutch retainer as shown in (Fig. 293).
Fig. 293 Install OD/Reverse Piston
1 - PUSH DOWN TO INSTALL OVERDRIVE/REVERSE PISTON
2 - INPUT CLUTCHES RETAINER
NOTE: The OD/UD Reaction Plate, Snap Rings, and
Input Clutch Retainer are not interchangeable with
previous year 41TE components. The snap rings
are thicker and the position of the ring lands have
changed.
TRANSAXLE 21 - 115