Dodge Intrepid Service Manual page 593

21 - 46 TRANSAXLE
42LE AUTOMATIC TRANSAXLE (Continued)
Fig. 143 Install Overdrive Accumulator and Springs
1 - OVERDRIVE ACCUMULATOR PISTON
2 - RETURN SPRINGS
3 - SEAL RING
4 - SEAL RING
CAUTION: Do not handle the valve body by the
manual shaft. Damage could result.
(51) Install valve body into place as shown in (Fig.
144).
Fig. 144 Install Valve Body To Transaxle
1 - VALVE BODY
(52) Install seven (7) valve body-to-case bolts (Fig.
145) and torque to 12 N·m (105 in. lbs.).
(53) Install transaxle oil filter (Fig. 146).
(54) Install transaxle oil pan (Fig. 147) with a
bead of Mopar ATF RTV (MS-GF41). Torque oil pan-
to-case bolts to 23 N·m (17 ft. lbs.).
Fig. 145 Install Valve Body Bolts (7)
1 - EXTENSION
2 - SOCKET
3 - VALVE BODY
Fig. 146 Install Transaxle Oil Filter
1 - TRANSAXLE FILTER
2 - FILTER RETAINING CLIPS
Install both speed sensors from transaxle case (Fig.
148). Torque speed sensors to 27 N·m (20 ft. lbs.).
(55) As a final check of the transaxle, measure the
input shaft end play. This will indicate when a #4
thrust plate change is required. The number 4 thrust
plate is located behind the overdrive clutch hub.
Attach a dial indicator to transaxle bell housing with
its plunger seated against end of input shaft (Fig.
149). Move input shaft in and out to obtain end play
reading. End play specifications are 0.13 to 0.64 mm
(0.005 to 0.025 inch). If not within specifications,
make the necessary thrust plate adjustment.
LH