Dodge Intrepid Service Manual page 845

23 - 108 SUNROOF
HOUSING DRAIN HOSE (Continued)
(3) Connect the lower end of the drain tube to the
rubber grommet near the rear window of the vehicle.
(4) Connect the drain hose to the sunroof housing
and test drainage.
(5) Install shelf panel, ensure not to pinch the rub-
ber grommets (Refer to 23 - BODY/INTERIOR/REAR
SHELF TRIM PANEL - INSTALLATION).
(6) Install headliner (Refer to 23 - BODY/INTERI-
OR/HEADLINER - INSTALLATION).
(7) Connect the control switch wire connector.
Install control switch.
(8) Test for proper operation of the sunroof.
MODULE ASSEMBLY
REMOVAL
(1) Move the glass panel to the fully closed posi-
tion.
(2) Lower headliner as necessary to gain access to
the sunroof express module (Refer to 23 - BODY/IN-
TERIOR/HEADLINER - REMOVAL).
(3) Disconnect the express module wire harness
connectors. (Fig. 3)
(4) Remove express module screw.
(5) Remove express module from the keyway by
sliding module towards the center of the vehicle.
INSTALLATION
(1) Insert sunroof express module in the keyway
located in the sunroof module and slide the module
outward to lock it into position.
(2) Install the sunroof express module screw.
(3) Connect the wire connectors to the sunroof
express module.
(4) Install the headliner into position (Refer to 23 -
BODY/INTERIOR/HEADLINER - INSTALLATION).
(5) Test sunroof operation, adjust if necessary.
SUNSHADE
REMOVAL
(1) Open sunroof approximately 90% of the way.
(2) Push sunshade down until tabs clear glass.
(3) Move sunshade forward of glass panel.
(4) Using a flat blade tool, remove front guide
blocks from track. By pushing block toward the cen-
ter of the vehicle (Fig. 9).
(5) Slide the sunshade forward while lifting the
front through the opening until the rear guide blocks
are accessible.
CAUTION: Use care not to crease the sunshade
when removing or installing.
(6) Disengage rear guide blocks from track.
Fig. 9 SUNSHADE GUIDE BLOCK
1 - GUIDE BLOCK
2 - GUIDE BLOCK SPRING
INSTALLATION
(1) Install the sunshade from outside of the vehicle
with the sunroof 90% open.
(2) Put rear guide blocks into sunshade guide
track.
(3) Push sunshade back and down through the
sunroof opening.
(4) Using a flat blade tool, put front guide blocks
into the sunshade track. By pushing the block
towards the center of the vehicle.
(5) Push sunshade back to the glass panel.
(6) Push sunshade down until the sunshade clears
the glass then move sunshade rearward behind the
glass panel.
LH