Dodge Intrepid Service Manual page 797

23 - 60 INTERIOR
A-PILLAR TRIM
REMOVAL
(1) Remove instrument panel end cap.
(2) Disengage clips attaching trim to A-pillar by
pulling on trim (Fig. 1).
(3) Slide A-pillar trim rearward, to disengaging
from instrument panel top cover.
(4) Remove A-pillar trim from vehicle.
Fig. 1 A-PILLAR TRIM
1 - A-PILLAR TRIM
2 - CLIPS
INSTALLATION
(1) Slide A-pillar trim forward ensuring that the
trim engages with the instrument panel top cover.
(2) Engage clips to attach trim to A-pillar.
(3) Install instrument panel end cap.
ASSIST HANDLE
REMOVAL
(1) Pull and hold assist handle down.
(2) Remove screws attaching assist handle to roof
(Fig. 2).
(3) Remove assist handle from vehicle.
INSTALLATION
(1) Place assist handle in position on vehicle.
(2) Install screws to attach assist handle to roof.
BODY VENT
REMOVAL
(1) Open decklid.
(2) Move trunk carpet to access the air exhauster
in the right/left rear corner of the trunk (Fig. 3).
Fig. 2 FRONT ASSIST HANDLE
1 - ROOF
2 - HEADLINING
3 - ASSIST HANDLE
(3) From inside trunk push the air exhauster out-
ward to release clips.
(4) Reach under fascia and pull air exhauster out-
ward from trunk side panel.
(5) Remove air exhauster from vehicle.
Fig. 3 AIR EXHAUSTER
1 - AIR EXHAUSTER
2 - REAR TRUNK FENCE
3 - TRUNK CARPET
INSTALLATION
(1) Place air exhauster in position. Ensure that the
locator tab is aligned.
(2) Engage the upper half of the air exhauster
then push the lower half in until the clips click into
place.
(3) Install trunk carpet into position.
LH