Installation - Crankshaft Sprocket - Dodge Intrepid Service Manual

9 - 86 ENGINE 2.7L
TIMING BELT/CHAIN AND SPROCKETS (Continued)
Fig. 123 TIMING CHAIN TENSIONER ACTIVATING
(22) Install the timing chain cover, crankshaft
vibration damper, and cylinder head covers. (Refer to
9 - ENGINE/VALVE TIMING/TIMING BELT /
CHAIN COVER(S) - INSTALLATION) (Refer to 9 -
ENGINE/ENGINE BLOCK/VIBRATION DAMPER -
INSTALLATION) (Refer to 9 - ENGINE/CYLINDER
HEAD/CYLINDER HEAD COVER(S) - INSTALLA-
TION)
(23) Install camshaft position sensor and connect
electrical connector.
(24) Install upper intake manifold. (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
INSTALLATION)
NOTE: After installation of a reset tensioner, engine
noise will occur after initial start-up. This noise will
normally disappear within 5–10 seconds.

INSTALLATION - CRANKSHAFT SPROCKET

6780-1 and 8179 (Fig. 124) until sprocket bottoms
against crankshaft step flange. Use care not to rotate
crankshaft.
1 - SPECIAL TOOL 6780–1
2 - SPECIAL TOOL 8179
proper depth by measuring from sprocket outer face
to end of crankshaft (Fig. 125). Measurement should
read: 39.05 ±0.50 mm (1.5374 ±0.020 in.).
ENGINE/VALVE
AND SPROCKETS - INSTALLATION)
MANIFOLD -
(1) Install crankshaft sprocket using Special Tools
Fig. 124 Crankshaft Sprocket - Installation
(2) Verify that crankshaft sprocket is installed to
(3) Install primary timing chain. (Refer to 9 -
TIMING/TIMING
Fig. 125 Crankshaft Sprocket Depth Measurement
LH
BELT/CHAIN