Dodge Intrepid Service Manual page 849

23 - 112 WEATHERSTRIP/SEALS
FRONT DOOR GLASS RUN WEATHERSTRIP (Continued)
INSTALLATION
(1) Clean butyl material from door flange area.
(2) Place door run weatherstrip in position on win-
dow frame channel.
(3) Push door run weatherstrip into window frame
channel.
(4) Push weatherstrip into lower front channel
above door latch.
(5) Install door glass (Refer to 23 - BODY/DOOR -
FRONT/DOOR GLASS - INSTALLATION).
(6) Tighten side view mirror.
FRONT DOOR MOUNTED
WEATHERSTRIP
REMOVAL
(1) Using a fork type prying tool, disengage push
pin fasteners attaching weatherstrip to lower door
(Fig. 4).
(2) Remove weatherstrip from door.
Fig. 4 FRONT DOOR MOUNTED WEATHERSTRIP
1 - FRONT DOOR
2 - PUSH-IN FASTENERS
INSTALLATION
(1) Place door mounted weatherstrip in position.
(2) Engage push pin fasteners to attach weather-
strip to lower door.
(3) Verify door alignment and seal
REAR DOOR BODY MOUNTED
WEATHERSTRIP
REMOVAL
(1) Remove door opening sill plate (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM - REMOVAL).
(2) Pull body mounted weatherstrip from fence
around door opening (Fig. 5).
Fig. 5 REAR DOOR BODY MOUNTED
WEATHERSTRIP
1 - REAR DOOR OPENING
2 - REAR DOOR BODY MOUNTED WEATHERSTRIP
3 - PINCH FLANGE
INSTALLATION
(1) Position color dot on weatherstrip at the B-pil-
lar upper corner.
(2) Engage weatherstrip on the fence at upper
B-pillar and work down the B-pillar.
(3) Engage weatherstrip along the header and
down the C-pillar.
(4) Engage weatherstrip along the sill. There may
be slack material, work the slack material to the
front of the opening.
(5) Install the door opening sill plate (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM - INSTALLA-
TION).
(6) Verify weatherstrip sealing.
LH