Sun Visor - Dodge Intrepid Service Manual

23 - 74 INTERIOR

SUN VISOR

REMOVAL
All vehicles with driver and passenger side air
bags must have a colored coded five Bullet point air-
bag warning label applied to the sun visor, verify
label availability and ensure the label is installed.
(1) Remove screw attaching inboard visor retainer
to over head. (Fig. 25).
(2) Remove screws attaching outboard visor pivot
base to roof.
(3) Disconnect visor vanity lamp wire connector, if
equipped.
(4) Remove visor from vehicle.
Fig. 25 SUN VISOR
1 - VISOR PIVOT BASE
2 - WIRE CONNECT
3 - RETAINER
4 - VISOR
INSTALLATION
All vehicles with driver and passenger side airbags
must have a colored coded five bullet point airbag
warning label applied to the sun visor, verify label
availability and ensure the label is installed.
(1) Engage visor vanity lamp wire connector, if
equipped.
(2) Place visor in position on header.
(3) Install screws attaching outboard visor pivot
base to over head.
(4) Install screw attaching inboard visor retainer
to over head.
TRUNK LINING
REMOVAL
(1) Remove rear seat cushion and back.
(2) Remove fasteners at forward edge along wheel-
housing
(3) Remove spare tire board, jack, and tire.
(4) Remove fasteners at back panel and sides.
(5) Remove carpet.
INSTALLATION
(1) Fold carpet and load into position in the trunk.
(2) Install fasteners at back and sides panel.
(3) Install spare tire board, jack, and tire.
(4) Install fasteners at forward edge along wheel-
housing
(5) Install rear seat back and cushion.
UPPER QUARTER TRIM
REMOVAL
(1) Disengage clips attaching upper quarter trim
to inner quarter panel (Fig. 21).
NOTE: Start at top forward area of trim and pull
inboard.
(2) Remove seat cushion.
(3) Remove lower seat belt anchor nut.
(4) Slide seat belt through trim panel.
(5) Remove upper quarter trim from vehicle.
INSTALLATION
(1) Slide belt through trim panel.
(2) Place upper quarter trim in position on vehicle.
(3) Engage clips attaching upper quarter trim to
inner quarter panel.
NOTE: Start at lower attachments first and work up.
(4) Install seat belt anchor nut.
(5) Install seat cushion.
LH