Dodge Intrepid Service Manual page 779

23 - 42 HOOD
LATCH (Continued)
Fig. 4 HOOD LATCH - INTREPID
1 - HOOD BUMPER ADJUSTER
2 - HOOD LATCH
3 - RELEASE CABLE CLIP
4 - NUTS
LATCH RELEASE CABLE
REMOVAL
(1) Release hood latch by using the inside release, if
still functioning. If not reach up through the bottom of
the fascia opening and release the latch pawl lever.
(2) Disconnect hood release cable ferrule and cable
end from hood latch assembly (Fig. 5) or (Fig. 6).
(3) Remove left cowl side trim panel.
(4) Remove screws attaching hood latch release
cable handle to the cowl side.
Fig. 5 HOOD RELEASE CABLE - CONCORDE/300M
1 - HOOD LATCH
2 - HOOD RELEASE CABLE
(5) Remove left wheel splash shield.
(6) Disengage release cable from routing clips.
(7) Roll carpet back to expose cable.
(8) Release taped on cable clip from dash liner
(Fig. 7).
(9) Release the rubber grommet from the dash
panel. Pull cable through the dash panel access hole.
(10) Remove cable from vehicle.
Fig. 6 HOOD RELEASE CABLE - INTREPID
1 - HOOD LATCH
2 - HOOD RELEASE CABLE
Fig. 7 HOOD RELEASE HANDLE
1 - RUBBER GROMMET
2 - SCREWS
3 - HOOD RELEASE HANDLE
4 - HOOD RELEASE CABLE
LH