Dodge Intrepid Service Manual page 511

19 - 34 GEAR
GEAR (Continued)
Fig. 9 In-Line Resonator And Air Inlet Hose
1 - AIR INLET HOSE
2 - THROTTLE BODY
3 - AIR INLET HOSE
4 - AIR CLEANER HOUSING LID
5 - RESONATOR
6 - IN-LINE RESONATOR
Fig. 10 Wiring Harness
1 - SPEED PROPORTIONAL STEERING SOLENOID
CONNECTOR
2 - MASTER CYLINDER RESERVOIR
(12) Remove the two nuts mounting the master
cylinder to the vacuum booster (Fig. 11).
Fig. 11 Master Cylinder To Vacuum Booster
Mounting
1 - MOUNTING NUT
2 - MASTER CYLINDER
3 - MOUNTING NUT
4 - VACUUM BOOSTER
(13) Disconnect the brake fluid level switch con-
nector on the side of the master cylinder fluid reser-
voir.
(14) Remove the master cylinder with the brake
tubes connected from the power brake vacuum
booster. Carefully position the master cylinder in an
upright position on the left side valve cover of the
engine.
CAUTION: Do not allow brake fluid to leak onto
painted surfaces. Paint damage may occur.
(15) Remove the vacuum supply hose to the power
brake vacuum booster at the check valve in the vac-
uum booster. Position the vacuum hose out of the
way.
(16) Bend back the retaining tabs on the mounting
plate for the tie rod to steering gear mounting bolts
(Fig. 12).
(17) Remove the bolts, mounting plate and wash-
ers attaching the tie rods to the steering gear (Fig.
13). Lay the tie rods on top of the transaxle bell
housing.
NOTE: The following step should be done to pre-
vent excessive spilling of power steering fluid when
the power steering fluid lines are removed from the
steering gear.
LH