Window Regulator - Dodge Intrepid Service Manual

23 - 26 DOOR - FRONT
TRIM PANEL - WOOD TRIM (Continued)
Fig. 16 WOOD TRIM - TYPICAL
1 - MOUNTING HOLES
2 - WOOD TRIM
WATERDAM
REMOVAL
(1) Remove door trim panel.(Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Carefully remove by pulling water dam from
door inner panel.
(3) Pull watershield around umbrella clips in sheet
metal inner panel.
INSTALLATION
(1) Position watershield on door inner panel.
Ensure that the water dam locator holes align and
watershield is over the umbrella clips.
(2) Press inward on areas with adhesive to attach
dam to inner door. Ensure that the dam is sealed.
(3) Install trim panel.(Refer to 23 - BODY/DOOR -
FRONT/TRIM PANEL - INSTALLATION)

WINDOW REGULATOR

REMOVAL
(1) Remove flag cover, door trim panel, water
shield as necessary, and pull cup support bracket.(Re-
fer to 23 - BODY/DOOR - FRONT/TRIM PANEL -
REMOVAL)
(2) Slide glass from regulator roller channel.
(3) Disconnect power window motor wire connector.
(4) Loosen bolt attaching regulator support brace
to door panel.
(5) Remove screw and bolt heads from keyhole
slots in door panel.
(6) Loosen bolts attaching regulator to door panel.
(7) Remove regulator from door panel.
(8) Slide regulator rearward and rotate forward
end of roller channel through access hole in door
panel (Fig. 17).
Fig. 17 WINDOW REGULATOR
1 - FRONT DOOR
2 - LIFT PLATES
3 - GLASS
4 - GLASS ROLLER CHANNEL
5 - WINDOW REGULATOR
INSTALLATION
(1) Insert roller channel through access hole in
door panel.
(2) Insert bolt heads on regulator through key hold
slots in door panel.
(3) Tighten bolts attaching regulator to door panel.
(4) Tighten bolt to attach regulator support brace
to door panel.
(5) Tighten screw to attach regulator scissor chan-
nel to door panel.
(6) Connect power window motor wire connector.
(7) Lower door glass on to regulator roller channel.
(8) Align glass and verify operation.
(9) Install pull cup support bracket, water shield,
door trim panel and flag cover.
LH