Cylinder Head Cover(S) Removal - Dodge Intrepid Service Manual

9 - 30 ENGINE 2.7L
CAMSHAFT(S) (Continued)
Fig. 21 Camshaft End Play Measuring
1 - DIAL INDICATOR
Fig. 22 Camshaft Bearing Cap Tightening Sequence
CYLINDER HEAD COVER(S)
REMOVAL
(1) Remove upper intake manifold. (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
REMOVAL)
(2) Remove electrical connectors from ignition
coils.
(3) Remove ground strap from right cylinder head.
(4) Disconnect electrical and vacuum harness
retaining clips from cylinder head cover studs.
(5) Remove fasteners attaching ignition coil capac-
itors.
(6) Loosen all cylinder head cover attaching bolts
(Fig. 26).
1 - ACTUAL WEAR
2 - BEARING JOURNAL
3 - EXHAUST CAMSHAFT
4 - INTAKE CAMSHAFT
5 - LOBE
MANIFOLD -
1 - VISE
2 - LOCK PIN
NOTE: Cylinder head cover attaching bolts are cap-
tured to the cover.
Fig. 23 Camshaft Inspection
Fig. 24 Locking Camshaft (Secondary) Chain
Tensioner
(7) Remove cylinder head covers.
LH