Dodge Intrepid Service Manual page 767

23 - 30 DOORS - REAR
LATCH (Continued)
1 - TO LOCK BUTTON
2 - CLIPS
3 - WIRE CONNECT
INSTALLATION
(1) Place latch in position in door.
(2) Install screws attaching door latch to door end
frame.
(3) Connect outside door handle link to door latch.
(4) Connect lock button link to door latch.
(5) Install rear glass channel.
(6) Verify door latch operation.
(7) Install door trim panel.(Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - INSTALLATION)
LATCH STRIKER
REMOVAL
(1) Open rear door.
(2) Mark location of door latch striker on C-pillar
to assist installation alignment.
(3) Remove bolts holding striker to C-pillar (Fig.
7).
(4) Remove door latch striker from vehicle.
INSTALLATION
(1) Place door latch striker in position on vehicle.
(2) Install bolts attaching striker to C-pillar.
(3) Align striker to marked location on C-pillar
and tighten bolts.
Fig. 6 REAR DOOR LATCH
4 - REAR DOOR LATCH
5 - TO DOOR HANDLE
1 - C-PILLAR
2 - DOOR LATCH STRIKER
(4) Verify alignment and operation of door, adjust
as necessary.
Fig. 7 REAR DOOR LATCH STRIKER
LH