Maintaining Sata Solid State Drive In An Acx7100-32C; Removing A Sata Solid State Drive From An Acx7100-32C - Juniper ACX7100-32C Hardware Manual

6. If there is a cable management system, arrange the cable in the cable management system to prevent
the cable from dislodging or developing stress points. Secure the cable so that it does not support its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop in the
cable management system. Placing fasteners on the loop helps to maintain its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause problems that
are difficult to diagnose.
Maintaining SATA Solid State Drive in an
ACX7100-32C
IN THIS SECTION

Removing a SATA Solid State Drive from an ACX7100-32C | 104

Installing a SATA Solid State Drive in an ACX7100-32C | 106
Removing a SATA Solid State Drive from an ACX7100-32C
Before you remove an SATA SSD from the device, ensure that you have taken the necessary precautions
to prevent electrostatic discharge (ESD) damage (see
Ensure that you have the following parts and tools available to remove a SATA SSD from an
ACX7100-32C router:
• ESD grounding strap
• Antistatic bag or an antistatic mat
Prevention of Electrostatic Discharge Damage
104
).