Figure 33: Do Not Grasp The Connector Edge - Juniper MX240 Hardware Manual

MX240 Ethernet Services Router Hardware Guide
NOTE: A DPC weighs 13.1 lb (5.9 kg). Be prepared to accept the full weight of the
DPC as you lift it.
To hold a DPC vertically:
1.
2.
3.
If the DPC is horizontal before you grasp it, place your left hand around the faceplate
and your right hand along the bottom edge.
To hold a DPC horizontally:
1.
2.
You can rest the faceplate of the DPC against your body as you carry it.
As you carry the DPC, do not bump it against anything. DPC components are fragile.
Never hold or grasp the DPC anywhere except places that this document indicates.
In particular, never grasp the connector edge, especially at the power connector in
the corner where the connector and bottom edges meet (see Figure 33 on page 76).

Figure 33: Do Not Grasp the Connector Edge

76
Maintaining Packet Forwarding Engine Components
Orient the DPC so that the faceplate faces you. To verify orientation, confirm
that the text on the DPC is right-side up and the electromagnetic interference
(EMI) strip is on the right-hand side.
Place one hand around the DPC faceplate about a quarter of the way down from
the top edge. To avoid deforming the EMI shielding strip, do not press hard on
it.
Place your other hand at the bottom edge of the DPC.
Orient the DPC so that the faceplate faces you.
Grasp the top edge with your left hand and the bottom edge with your right hand.