Internet Access Setup - Wan Interface; Internet Access: Ethernet - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 4 Installation Setup Wizard

4.1.1 Internet Access Setup - WAN Interface

Use this screen to set how many WAN interfaces to configure and the first WAN
interface's type of encapsulation and method of IP address assignment.
The screens vary depending on the encapsulation type. Refer to information
provided by your ISP to know what to enter in each field. Leave a field blank if you
don't have that information.
Note: Enter the Internet access information exactly as your ISP gave it to you.
Figure 28 Internet Access: Step 1
• I have two ISPs: Select this option to configure two Internet connections.
Leave it cleared to configure just one. This option appears when you are
configuring the first WAN interface.
• Encapsulation: Choose the Ethernet option when the WAN port is used as a
regular Ethernet. Otherwise, choose PPPoE or PPTP for a dial-up connection
according to the information from your ISP.
• WAN Interface: This is the interface you are configuring for Internet access.
• Zone: This is the security zone to which this interface and Internet connection
belong.
• IP Address Assignment: Select Auto if your ISP did not assign you a fixed IP
address.
Select Static if the ISP assigned a fixed IP address.

4.1.2 Internet Access: Ethernet

This screen is read-only if you set the previous screen's IP Address Assignment
field to Auto. Use this screen to configure your IP address settings.
64
ZyWALL USG 100/200 Series User's Guide