Device Ha Technical Reference - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 39 Device HA
Table 191 Configuration > Device HA > Legacy Mode > Add (continued)
LABEL
VRID
Virtual Router
IP (VRIP) /
Subnet Mask
Authentication
OK
Cancel

39.7 Device HA Technical Reference

Active-Passive Mode Device HA with Bridge Interfaces
Here are two ways to avoid a broadcast storm when you connect the bridge
interfaces on two ZyWALLs.
First Option for Connecting the Bridge Interfaces on Two ZyWALLs
The first way is to activate device HA before connecting the bridge interfaces as
shown in the following example.
714
DESCRIPTION
Type the virtual router ID number.
This is the interface's IP address and subnet mask in the virtual router.
Select the authentication method used in the virtual router. Every
interface in a virtual router must use the same authentication method
and password. Choices are:
None - this virtual router does not use any authentication method.
Text - this virtual router uses a plain text password for authentication.
Type the password in the field next to the radio button. The password
can consist of alphanumeric characters, the underscore, and some
punctuation marks (+-/*= :; .! @$&%#~ ' \ () ), and it can be up to
eight characters long.
IP AH (MD5) - this virtual router uses an encrypted MD5 password for
authentication. Type the password in the field next to the radio button.
The password can consist of alphanumeric characters, the underscore,
and some punctuation marks (+-/*= :; .! @$&%#~ ' \ () ), and it can
be up to eight characters long.
See Authentication Types on page 405
authentication methods.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
for more information about
ZyWALL USG 100/200 Series User's Guide