Pre-Defined Ntp Time Servers List - ZyXEL Communications ZyWALL USG 200 Series User Manual

Table 233 Configuration > System > Date and Time (continued)
LABEL
End Date
Offset
Apply
Reset

50.3.1 Pre-defined NTP Time Servers List

When you turn on the ZyWALL for the first time, the date and time start at 2003-
01-01 00:00:00. The ZyWALL then attempts to synchronize with one of the
following pre-defined list of Network Time Protocol (NTP) time servers.
The ZyWALL continues to use the following pre-defined list of NTP time servers if
you do not specify a time server or it cannot synchronize with the time server you
specified.
Table 234 Default Time Servers
0.pool.ntp.org
1.pool.ntp.org
2.pool.ntp.org
When the ZyWALL uses the pre-defined list of NTP time servers, it randomly
selects one server and tries to synchronize with it. If the synchronization fails,
then the ZyWALL goes through the rest of the list in order from the first one tried
until either it is successful or all the pre-defined NTP time servers have been tried.
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Configure the day and time when Daylight Saving Time ends if you
selected Enable Daylight Saving. The at field uses the 24 hour
format. Here are a couple of examples:
Daylight Saving Time ends in the United States on the first Sunday of
November. Each time zone in the United States stops using Daylight
Saving Time at 2 A.M. local time. So in the United States you would
select First, Sunday, November and type 2 in the at field.
Daylight Saving Time ends in the European Union on the last Sunday
of October. All of the time zones in the European Union stop using
Daylight Saving Time at the same moment (1 A.M. GMT or UTC). So in
the European Union you would select Last, Sunday, October. The
time you type in the at field depends on your time zone. In Germany
for instance, you would type 2 because Germany's time zone is one
hour ahead of GMT or UTC (GMT+1).
Specify how much the clock changes when daylight saving begins and
ends.
Enter a number from 1 to 5.5 (by 0.5 increments).
For example, if you set this field to 3.5, a log occurred at 6 P.M. in local
official time will appear as if it had occurred at 10:30 P.M.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 50 System
819