Address Group Summary Screen - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 41 Addresses
Table 202 Configuration > Object > Address > Address > Edit (continued)
LABEL
Interface
OK
Cancel

41.3 Address Group Summary Screen

The Address Group screen provides a summary of all address groups. To access
this screen, click Configuration > Object > Address > Address Group. Click a
column's heading cell to sort the table entries by that column's criteria. Click the
heading cell again to reverse the sort order.
Figure 496 Configuration > Object > Address > Address Group
The following table describes the labels in this screen. See
741 for more information as well.
Table 203 Configuration > Object > Address > Address Group
LABEL
Add
Edit
Remove
Object
References
#
Name
Description
740
DESCRIPTION
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE
GATEWAY as the Address Type, use this field to select the interface of
the network that this address object represents.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the
entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Select an entry and click Object References to open a screen that
shows which settings use the entry. See
an example.
This field is a sequential value, and it is not associated with a specific
address group.
This field displays the name of each address group.
This field displays the description of each address group, if any.
Section 41.3.1 on page
Section 13.3.2 on page 306
ZyWALL USG 100/200 Series User's Guide
for