ZyXEL Communications ZyWALL USG 200 Series User Manual page 610

Chapter 34 IDP
Table 165 Configuration > Anti-X > IDP > Profile: Query View (continued)
LABEL
Severity
Attack Type
Platform
Service
Action
Activation
Log
Search
Query Result
OK
Cancel
Save
610
DESCRIPTION
Search for signatures by severity level(s). Hold down the [Ctrl] key if
you want to make multiple selections.
These are the severities as defined in the ZyWALL. The number in
brackets is the number you use if using commands.
Severe (5): These denote attacks that try to run arbitrary code or gain
system privileges.
High (4): These denote known serious vulnerabilities or attacks that are
probably not false alarms.
Medium (3): These denote medium threats, access control attacks or
attacks that could be false alarms.
Low (2): These denote mild threats or attacks that could be false
alarms.
Very-Low (1): These denote possible attacks caused by traffic such as
Ping, trace route, ICMP queries etc.
Search for signatures by attack type(s) (see
Attack types are known as policy types in the group view screen. Hold
down the [Ctrl] key if you want to make multiple selections.
Search for signatures created to prevent intrusions targeting specific
operating system(s). Hold down the [Ctrl] key if you want to make
multiple selections.
Search for signatures by IDP service group(s). See
607 for group details. Hold down the [Ctrl] key if you want to make
multiple selections.
Search for signatures by the response the ZyWALL takes when a packet
matches a signature. See
down the [Ctrl] key if you want to make multiple selections.
Search for activated and/or inactivated signatures here.
Search for signatures by log option here. See
option details.
Click this button to begin the search. The results display at the bottom
of the screen. Results may be spread over several pages depending on
how broad the search criteria selected were. The tighter the criteria
selected, the fewer the signatures returned.
The results are displayed in a table showing the SID, Name, Severity,
Attack Type, Platform, Service, Activation, Log, and Action criteria
as selected in the search. Click the SID column header to sort search
results by signature ID.
Click OK to save your settings to the ZyWALL, complete the profile and
return to the profile summary page.
Click Cancel to return to the profile summary page without saving any
changes.
Click Save to save the configuration to the ZyWALL, but remain in the
same page. You may then go to the another profile screen (tab) in order
to complete the profile. Click OK in the final profile screen to complete
the profile.
Table 163 on page
Table 162 on page 604 for action details. Hold
Table 162 on page 604
ZyWALL USG 100/200 Series User's Guide
606).
Table 164 on page
for