Ethernet Edit - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 13 Interfaces
Each field is described in the following table.
Table 60 Configuration > Network > Interface > Ethernet
LABEL
Edit
Remove
Activate
Inactivate
Create Virtual
Interface
Object References Select an entry and click Object References to open a screen that
#
Status
Name
IP Address
Mask
Apply
Reset

13.3.1 Ethernet Edit

The Ethernet Edit screen lets you configure IP address assignment, interface
parameters, RIP settings, OSPF settings, DHCP settings, connectivity check, and
MAC address settings. To access this screen, click an Edit icon in the Ethernet
Summary screen. (See
The OPT interface's Edit > Configuration screen is shown here as an example.
The screens for other interfaces are similar and contain a subset to the OPT
interface screen's fields.
Note: If you create IP address objects based on an interface's IP address, subnet, or
gateway, the ZyWALL automatically updates every rule or setting that uses the
object whenever the interface's IP address settings change. For example, if you
change LAN1's IP address, the ZyWALL automatically updates the
corresponding interface-based, LAN1 subnet address object.
298
DESCRIPTION
Double-click an entry or select it and click Edit to open a screen
where you can modify the entry's settings.
To remove a virtual interface, select it and click Remove. The
ZyWALL confirms you want to remove it before doing so.
To turn on an interface, select it and click Activate.
To turn off an interface, select it and click Inactivate.
To open the screen where you can create a virtual Ethernet interface,
select an Ethernet interface and click Create Virtual Interface.
shows which settings use the entry. See
for an example.
This field is a sequential value, and it is not associated with any
interface.
This icon is lit when the entry is active and dimmed when the entry is
inactive.
This field displays the name of the interface.
This field displays the current IP address of the interface. If the IP
address is 0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address
(STATIC) or dynamically assigned (DHCP). IP addresses are always
static in virtual interfaces.
This field displays the interface's subnet mask in dot decimal notation.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Section 13.3 on page
Section 13.3.2 on page 306
296.)
ZyWALL USG 100/200 Series User's Guide