ZyXEL Communications ZyWALL USG 200 Series User Manual page 713

The following table describes the labels in this screen.
Table 191 Configuration > Device HA > Legacy Mode > Add
LABEL
Show Advance
Settings / Hide
Advance
Settings
Enable VRRP
Group
Name
Description
Interface
Name
Manage IP
Manage IP
Subnet Mask
Role
Priority
Preempt
Virtual Router
Settings
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Click this button to display a greater or lesser number of configuration
fields.
Select this to make the specified interface part of the virtual router. Clear
this to take the specified interface out of the virtual router. Enabling a
VRRP group has the ZyWALL monitor the connection of the group's
interface.
This field is read-only if you are editing the VRRP group. Type the name
of the VRRP group. This field must be unique in the ZyWALL, but it is not
used in the virtual router. The virtual router uses the VRID. The name
can consist of alphanumeric characters, the underscore, and the dash
and may be up to fifteen characters long.
Type the description of the VRRP group. This field is only for your
reference. It may be up to sixty printable ASCII characters long.
Select the interface in this device that is part of the virtual router. You
can only select interfaces that have static IP addresses. Connect the
interface to the same subnet as the group's interface on the other
ZyWALL.
Enter the interface's IP address for management access. You can use
this IP address to access the ZyWALL whether it is the master or a
backup. This management IP address should be in the same subnet as
the interface IP address so the backup ZyWALL cannot synchronize with
the master via this VRRP interface.
Enter the subnet mask of the interface's management IP address.
Select the role that you want the interface to play in the virtual router.
Choices are:
Master - This interface is the master interface in the virtual router. The
interface always uses its virtual IP address when its status is active.
Note: Do not set this field to Master for two or more ZyWALLs in the
same virtual router (same VR ID).
Backup - This interface is a backup interface in the virtual router. The
current role depends on the other ZyWALLs in the virtual router.
This field is available if the selected interface is a Backup interface. Type
the priority of the backup interface. The backup interface with the
highest value takes over the role of the master interface if the master
interface becomes unavailable. The priority must be between 1 and 254.
(The master interface has priority 255.)
This field is available if the selected interface is a Backup interface.
Select this if the selected interface should become the master interface if
a lower-priority interface is the master when this one is enabled. (If the
role is Master, the interface preempts by default.)
Chapter 39 Device HA
713