ZyXEL Communications ZyWALL USG 200 Series User Manual page 469

Table 124 Configuration > Firewall > Session Limit > Edit (continued)
LABEL
User
Address
Session Limit
per Host
OK
Cancel
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Select a user name or user group to which to apply the rule. The rule is
activated only when the specified user logs into the system and the rule
will be disabled when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user's IP address should be within
the IP address range.
Select a source address or address group for whom this rule applies.
Select any if the policy is effective for every source address.
Use this field to set a limit to the number of concurrent NAT/firewall
sessions this rule's users or addresses can have.
For this rule's users and addresses, this setting overrides the Default
Session per Host setting in the general Firewall Session Limit
screen.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Chapter 24 Firewall
469