Cellular Add/Edit Screen - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 13 Interfaces
Figure 273 Configuration > Network > Interface > Cellular
The following table describes the labels in this screen.
Table 66 Configuration > Network > Interface > Cellular
LABEL
Add
Edit
Remove
Activate
Inactivate
Connect
Disconnect
Object
References
#
Status
Name
Extension Slot
Connected
Device
ISP Settings
Apply
Reset

13.5.1 Cellular Add/Edit Screen

To change your 3G settings, click Configuration > Network > Interface >
Cellular > Add (or Edit). In the pop-up window that displays, select the slot that
you want to configure. The following screen displays.
316
DESCRIPTION
Click this to create a new cellular interface.
Double-click an entry or select it and click Edit to open a screen where
you can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To connect an interface, select it and click Connect. You might use this
in testing the interface or to manually establish the connection.
To disconnect an interface, select it and click Disconnect. You might
use this in testing the interface.
Select an entry and click Object References to open a screen that
shows which settings use the entry. See
an example.
This field is a sequential value, and it is not associated with any
interface.
The activate (light bulb) icon is lit when the entry is active and dimmed
when the entry is inactive.
The connect icon is lit when the interface is connected and dimmed
when it is disconnected.
This field displays the name of the interface.
This field displays where the entry's cellular card is located.
This field displays the name of the cellular card.
This field displays the profile of ISP settings that this cellular interface is
set to use.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Section 13.3.2 on page 306
ZyWALL USG 100/200 Series User's Guide
for