The Anti-Spam Policy Add Or Edit Screen - ZyXEL Communications ZyWALL USG 200 Series User Manual

Table 181 Configuration > Anti-X > Anti-Spam > General
LABEL
Remove
Activate
Inactivate
Move
Status
Priority
From
To
Protocol
Apply
Reset

38.3.1 The Anti-Spam Policy Add or Edit Screen

Click the Add or Edit icon in the Configuration > Anti-X > Anti-Spam >
General screen to display the configuration screen as shown next. Use this screen
to configure an anti-spam policy that controls what traffic direction of e-mail to
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Select an entry and click this to delete it.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To change an entry's position in the numbered list, select it and click
Move to display a field to type a number for where you want to put that
entry and press [ENTER] to move the entry to the number that you
typed.
The activate (light bulb) icon is lit when the entry is active and dimmed
when the entry is inactive.
This is the position of an anti-spam policy in the list. The ordering of your
anti-spam policies is important as the ZyWALL applies them in sequence.
Once traffic matches an anti-spam policy, the ZyWALL applies that policy
and does not check the traffic against any more policies.
The anti-spam policy has the ZyWALL scan e-mail traffic that is coming
from this zone and going to the To zone.
The anti-spam policy has the ZyWALL scan e-mail traffic that is going to
this zone from the From zone.
These are the protocols of traffic to scan for spam. SMTP applies to
traffic using TCP port 25. POP3 applies to traffic using TCP port 110.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 38 Anti-Spam
685