ZyXEL Communications ZyWALL USG 200 Series User Manual page 301

This screen's fields are described in the table below.
Table 61 Configuration > Network > Interface > Ethernet > Edit
LABEL
Show Advance
Settings / Hide
Advance Settings
General Settings
Enable
Interface
Interface
Properties
Interface Type
Interface
Name
Port
Zone
MAC Address
Description
IP Address
Assignment
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Click this button to display a greater or lesser number of configuration
fields.
Select this to enable this interface. Clear this to disable this interface.
This is field is configurable for the OPT interface. Select to which type
of network you will connect this interface. When you select Internal
or External the rest of the screen's options automatically adjust to
correspond. The ZyWALL automatically adds default route and SNAT
settings for traffic it routes from internal interfaces to external
interfaces; for example LAN to WAN traffic.
Internal is for connecting to a local network. Other corresponding
configuration options: DHCP server and DHCP relay. The ZyWALL
automatically adds default SNAT settings for traffic flowing from this
interface to an external interface.
External is for connecting to an external network (like the Internet).
The ZyWALL automatically adds this interface to the default WAN
trunk.
For General, the rest of the screen's options do not automatically
adjust and you must manually configure a policy route to add routing
and SNAT settings for the interface.
Specify a name for the interface. It can use alphanumeric characters,
hyphens, and underscores, and it can be up to 11 characters long.
This is the name of the Ethernet interface's physical port.
Select the zone to which this interface is to belong. You use zones to
apply security settings such as firewall, IDP, remote management,
anti-virus, and application patrol.
This field is read-only. This is the MAC address that the Ethernet
interface uses.
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
These IP address fields configure an IP address on the interface itself.
If you change this IP address on the interface, you may also need to
change a related address object for the network connected to the
interface. For example, if you use this screen to change the IP
address of your LAN interface, you should also change the
corresponding LAN subnet address object.
Chapter 13 Interfaces
characters, and it can be
301