ZyXEL Communications ZyWALL USG 200 Series User Manual page 708

Chapter 39 Device HA
A bridge interface's device HA settings are not retained if you delete the bridge
interface.
Figure 480 Configuration > Device HA > Active-Passive Mode > Edit
The following table describes the labels in this screen.
Table 189 Configuration > Device HA > Active-Passive Mode > Edit
LABEL
Enable
Monitored
Interface
Interface
Name
Virtual Router
IP (VRIP) /
Subnet Mask
Management
IP
Manage IP
Subnet Mask
OK
Cancel
708
DESCRIPTION
Select this to have device HA monitor the status of this interface's
connection.
This identifies the interface.
Note: Do not connect the bridge interfaces on two ZyWALLs without
device HA activated on both. Doing so could cause a
broadcast storm.
Either activate device HA before connecting the bridge interfaces or
disable the bridge interfaces, connect the bridge interfaces, activate
device HA, and finally reactivate the bridge interfaces.
This is the interface's (static) IP address and subnet mask in the virtual
router. Whichever ZyWALL is currently serving as the master uses this
virtual router IP address and subnet mask. These fields are blank if the
interface is a DHCP client or has no IP settings.
Enter the interface's IP address for management access. You can use
this IP address to access the ZyWALL whether it is the master or a
backup. This management IP address should be in the same subnet as
the interface IP address.
Enter the subnet mask of the interface's management IP address.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
ZyWALL USG 100/200 Series User's Guide