ZyXEL Communications ZyWALL USG 200 Series User Manual page 863

Table 250 Configuration > System > Vantage CNM (continued)
LABEL
Transfer
Protocol
Device
Management
IP
Custom IP
Keepalive
Interval
Periodic Inform
Interval
HTTPS
Authentication
Vantage
Certificate
Apply
Reset
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Select whether the Vantage CNM sessions should use regular HTTP
connections or secure HTTPS connections.
Note: HTTPS is recommended.
The Vantage CNM server must use the same setting.
Select Auto to have the ZyWALL allow Vantage CNM sessions to connect
to any of the ZyWALL's IP addresses.
Select Custom to specify the ZyWALL's IP address that allows Vantage
CNM sessions. Configure the Custom IP field if you select this. You
might for example need to specify the IP address when using a WAN
trunk that uses multiple WAN IP addresses.
Specify the ZyWALL's IP address that allows Vantage CNM sessions. This
field applies when you select Custom in the Device Management IP
field.
Set how often the ZyWALL sends a keep alive packet to the Vantage
CNM server if there is no other traffic. The keep alive packets maintain
the Vantage CNM server's control session.
Select this option to have the ZyWALL periodically send "Inform"
messages to the Vantage CNM server.
When you are using HTTPs, select this option to have the ZyWALL
authenticate the Vantage CNM server's certificate. In order to do this
you need to import the Vantage CNM server's public key (certificate) into
the ZyWALL's trusted certificates.
Select the Vantage CNM server's certificate. This applies when you
enable HTTPS authentication.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 50 System
863