Static Routes; Zones; Ddns; Nat - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 6 Configuration Basics

6.5.7 Static Routes

Use static routes to tell the ZyWALL about networks not directly connected to the
ZyWALL.
MENU ITEM(S)
PREREQUISITES

6.5.8 Zones

See Section 6.2 on page 92
interfaces and VPN tunnels. The ZyWALL uses zones, not interfaces, in many
security settings, such as firewall rules and remote management.
Zones cannot overlap. Each interface and VPN tunnel can be assigned to at most
one zone. Virtual interfaces are automatically assigned to the same zone as the
interface on which they run. When you create a zone, the ZyWALL does not create
any firewall rules, assign an IDP profile, or configure remote management for the
new zone.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: For example, to create the DMZ-2 zone and add ext-wlan, click
Network > Zone and then the Add icon.

6.5.9 DDNS

Dynamic DNS maps a domain name to a dynamic IP address. The ZyWALL helps
maintain this mapping.
MENU ITEM(S)
PREREQUISITES

6.5.10 NAT

Use Network Address Translation (NAT) to make computers on a private network
behind the ZyWALL available outside the private network.
104
Configuration > Network > Routing > Static Route
Interfaces
for background information. A zone is a group of
Configuration > Network > Zone
Interfaces, IPSec VPN, SSL VPN
Firewall, IDP, remote management, anti-virus, ADP, application patrol
Configuration > Network > DDNS
Interface
ZyWALL USG 100/200 Series User's Guide