32.2 Application Patrol General Screen
Use this screen to enable and disable application patrol. It also lists the
registration status and details about the signature set the ZyWALL is using.
Note: You must register for the IDP/AppPatrol signature service (at least the trial)
before you can use it.
See
Chapter 11 on page 279
Click Configuration > App Patrol to open the following screen.
Figure 415 Configuration > App Patrol > General
The following table describes the labels in this screen. See
565
for more information as well.
Table 146 Configuration > App Patrol > General
LABEL
Enable
Application
Patrol
Enable BWM
ZyWALL USG 100/200 Series User's Guide
for how to register.
DESCRIPTION
Select this check box to turn on application patrol.
This is a global setting for enabling or disabling bandwidth management
on the ZyWALL. You must enable this setting to have individual policy
routes or application patrol policies apply bandwidth management.
This same setting also appears in the Network > Routing > Policy
Route screen. Enabling or disabling it in one screen also enables or
disables it in the other screen.
Chapter 32 Application Patrol
Section 32.3.1 on page
563