Static Route Add/Edit Screen - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 15 Policy and Static Routes
The following table describes the labels in this screen.
Table 92 Configuration > Network > Routing > Static Route
LABEL
Add
Edit
Remove
#
Destination
Subnet Mask
Next-Hop
Metric

15.3.1 Static Route Add/Edit Screen

Select a static route index number and click Add or Edit. The screen shown next
appears. Use this screen to configure the required information for a static route.
Figure 301 Configuration > Network > Routing > Static Route > Add
The following table describes the labels in this screen.
Table 93 Configuration > Network > Routing > Static Route > Add
LABEL
Destination IP
Subnet Mask
388
DESCRIPTION
Click this to create a new static route.
Double-click an entry or select it and click Edit to open a screen where
you can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
This is the number of an individual static route.
This is the destination IP address.
This is the IP subnet mask.
This is the IP address of the next-hop gateway or the interface through
which the traffic is routed. The gateway is a router or switch on the same
segment as your ZyWALL's interface(s). The gateway helps forward
packets to their destinations.
This is the route's priority among the ZyWALL's routes. The smaller the
number, the higher priority the route has.
DESCRIPTION
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Enter the IP subnet mask here.
ZyWALL USG 100/200 Series User's Guide