ZyXEL Communications ZyWALL USG 200 Series User Manual page 576

Chapter 32 Application Patrol
Table 151 AppPatrol > Other > Edit (continued)
LABEL
Schedule
User
From
To
Source
Destination
Protocol
Access
DSCP Marking
Bandwidth
Management
576
DESCRIPTION
Select a schedule that defines when the policy applies or select Create
Object to configure a new one (see
Otherwise, select any to make the policy always effective.
Select a user name or user group to which to apply the policy. Use
Create new Object if you need to configure a new user account (see
Section 40.2.1 on page 724
for every user.
Select the source zone of the traffic to which this policy applies.
Select the destination zone of the traffic to which this policy applies.
Select a source address or address group for whom this policy applies.
Use Create new Object if you need to configure a new one. Select any
if the policy is effective for every source.
Select a destination address or address group for whom this policy
applies. Use Create new Object if you need to configure a new one.
Select any if the policy is effective for every destination.
Select the protocol for which this condition applies. Choices are: TCP
and UDP. Select any to apply the policy to both TCP and UDP traffic.
This field controls what the ZyWALL does with packets that match this
policy. Choices are:
forward - the ZyWALL routes the packets.
Drop - the ZyWALL does not route the packets and does not notify the
client of its decision.
Reject - the ZyWALL does not route the packets and notifies the client
of its decision.
Set how the ZyWALL handles the DSCP value of the outgoing packets
that match this policy. Inbound refers to the traffic the ZyWALL sends to
a connection's initiator. Outbound refers to the traffic the ZyWALL sends
out from a connection's initiator.
Select one of the pre-defined DSCP values to apply or select User
Defined to specify another DSCP value. The "af" choices stand for
Assured Forwarding. The number following the "af" identifies one of four
classes and one of three drop preferences. See
PHB for DiffServ on page 389
Select preserve to have the ZyWALL keep the packets' original DSCP
value.
Select default to have the ZyWALL set the DSCP value of the packets to
0.
Configure these fields to set the amount of bandwidth the application
can use. These fields only apply when Access is set to forward.
Chapter 43 on page 749
for details). Select any to apply the policy
Assured Forwarding (AF)
for more details.
ZyWALL USG 100/200 Series User's Guide
for details).