ZyXEL Communications ZyWALL USG 200 Series User Manual page 337

Figure 281 Network > Interface > WLAN > MAC Filter
The following table describes the labels in this screen.
Table 74 Configuration > Network > Interface > WLAN > MAC Filter
LABEL
Enable MAC
Filter
Association
Add
Edit
Remove
#
MAC
Address
Description
Apply
Reset
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Select or clear the check box to enable or disable MAC address filtering.
Enable MAC address filtering to have the router allow or deny access to
wireless stations based on MAC addresses. Disable MAC address filtering to
have the router not perform MAC filtering on the wireless stations.
Define the filter action for the list of MAC addresses in the MAC address
filter table.
Select Deny to block access to the router, MAC addresses not listed will be
allowed to access the router. Select Allow to permit access to the router,
MAC addresses not listed will be denied access to the router.
Click this to add an entry to the table.
Double-click an entry or select it and click Edit to be able to modify the
entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms you
want to remove it before doing so.
This is the index number of the MAC address.
This displays the MAC address (in XX:XX:XX:XX:XX:XX format) of the
wireless station that is allowed or denied access to the ZyWALL. Enter the
MAC address (in XX:XX:XX:XX:XX:XX or XX-XX-XX-XX-XX-XX format) of
the wireless station that is to be allowed or denied access to the ZyWALL.
Note that if you enter the MAC address using hyphens for the separators,
the ZyWALL automatically converts them to colons.
This field displays a descriptive name for the MAC address entry. Enter a
descriptive name for the MAC address entry.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 13 Interfaces
337