The Service Add/Edit Screen; The Service Group Summary Screen - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 42 Services

42.2.1 The Service Add/Edit Screen

The Service Add/Edit screen allows you to create a new service or edit an
existing one. To access this screen, go to the Service screen (see
page 744), and click either the Add icon or an Edit icon.
Figure 499 Configuration > Object > Service > Service > Edit
The following table describes the labels in this screen.
Table 206 Configuration > Object > Service > Service > Edit
LABEL
Name
IP Protocol
Starting Port
Ending Port
ICMP Type
IP Protocol
Number
OK
Cancel

42.3 The Service Group Summary Screen

The Service Group summary screen provides a summary of all service groups. In
addition, this screen allows you to add, edit, and remove service groups.
746
DESCRIPTION
Type the name used to refer to the service. You may use 1-31
alphanumeric characters, underscores(
character cannot be a number. This value is case-sensitive.
Select the protocol the service uses. Choices are: TCP, UDP, ICMP, and
User Defined.
This field appears if the IP Protocol is TCP or UDP. Specify the port
number(s) used by this service. If you fill in one of these fields, the
service uses that port. If you fill in both fields, the service uses the range
of ports.
This field appears if the IP Protocol is ICMP Type.
Select the ICMP message used by this service. This field displays the
message text, not the message number.
This field appears if the IP Protocol is User Defined.
Enter the number of the next-level protocol (IP protocol). Allowed values
are 0 - 255.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
), or dashes (-), but the first
_
ZyWALL USG 100/200 Series User's Guide
Section 42.2 on