Configuring Vtl Passwords In The Dial Plan - 3Com SuperStack 3 NBX Administrator's Manual

110 C 2: D P
HAPTER IAL
Configuring VTL
Passwords in the
Dial Plan
LAN
3 Click the Virtual Tie Lines Password button. The Change Virtual Tie Lines
Password dialog box (Figure 42) appears.
Figure 42 Change Virtual Tie Lines Password Dialog Box
4 Type the current administrator password in the Current Admin Password
text box.
5 Type the new VTL password in the New Virtual Tie Line Password text
box.
Passwords are from 8 to 15 characters in length and must contain only
letters and numbers. Upper and lower case letters are permitted.
6 Retype the new VTL password in the Re-enter New Password text box.
7 Click OK.
For each remote NBX system that controls hop-off by means of a VTL
password, you must configure that password into the VTL commands in
the local dial plan.
If you use site codes to access other NBX systems through VTL
connections, you can configure one set of VTL connections that permit
hop-off and are accessed one set of site codes. You can configure
another set of VTL connections that do not permit hop-off and are
accessed using a different set of site codes.