3Com SuperStack 3 NBX Administrator's Manual page 409

Table 75 Configuration and Status Report Headings (continued)
Heading Description
NCP Conne The amount of time that the digital line card waits for the NCP
to connect the call. "USER_ALERTING_NO_ANSWER" errors
mean that this value may be too small.
NCP Gener A timeout value that controls how long the digital line card waits
for a response from the call processor. Do not modify this value.
Network Digit A timeout value that controls how long the digital line card waits
between digits sent on an incoming call.
OffHk Min The minimum time an analog telephone, connected to an
Analog Terminal Card, must be off hook for the NBX system to
recognize that the telephone has been picked up.
On Line One possible status of a channel.
Protocol A signaling method used to make calls.
RxWnkMax The maximum duration of a received Wink signal.
RxWnkMin The minimum duration of a received Wink signal.
SpId Span ID.
SpNo Span number.
Group Name Name of this group.
Span MAC Address MAC address assigned to this span.
Span Name Name of span.
SpanNo Identifying number for a span.
Start Type Mechanism used to indicate start of a call.
Status Status of a channel, span, card. Values: Online, Idle, Unknown.
Default: Online
TEI For a BRI board, the Terminal Equipment Identification number.
The telco may provide this number or the system may assign it,
depending on how you purchased the BRI lines.
TEP Version The version of software running on the board.
Time Last Seen Last time activity was recorded for this board.
Timing Mode Internal: Timing is generated from within the digital line card.
Loop: Timing is taken from the central office.
Trunk to Trunk Whether call transfers are allowed from one trunk to another.
Values: Enabled (default), Disabled, Restricted, Unrestricted.
TxGudMin The minimum duration of a transmitted Guard signal.
TxWnkDura The duration of a transmitted Wink signal.
Wink Wait This time out value controls how long the digital line card waits
to respond with a wink signal on an outgoing call. If you see
"no_wink_received" errors, this value may be too small.
System-level Troubleshooting 409