3Com SuperStack 3 NBX Administrator's Manual page 178

178 C 3: D
HAPTER EVICE
C
ONFIGURATION
Table 26 Group Button Types (continued)
Group
Button Type Description
CLIR-All Normally, when an ISDN call is made, the identity of the caller is
provided to the PSTN and may be seen by the called party if they
subscribe to the Caller-ID service. CLIR allows you to withhold this
information from the called user.
This Group Button type assigns Calling Line Identity Restriction-All to
this button. When the user presses the button, all subsequent ISDN
calls made from this telephone no longer send calling party
information.
A user cannot enable CLIR-All from a locked telephone.
If the button has a light beside it, pressing the button causes the
light to turn on.
NOTE: Enabling CLIR-Next does not cause the lamp to light.
To turn off CLIR-All, press the button again. The light turns off.
Number — Not used.
Prty (Priority) — Not used.
CLIR-Next Normally, when an ISDN call is made, the identity of the caller is
provided to the PSTN and may be seen by the called party if they
subscribe to the Caller-ID service. CLIR allows you to withhold this
information from the called user.
This group button type assigns Calling Line Identity Restriction to this
button for the next call only. When the user presses the button, the
next ISDN call made from this telephone does not send calling party
information.
You cannot enable CLIR-Next from a locked telephone.
If the button has a light, pressing the button does not cause the light
to turn on.
After the user completes the call and hangs up, CLIR-Next becomes
inactive.
Number — Not used.
Prty (Priority) — Not used.
Switch to Enables this button to switch the currently active call from pulse
DTMF dialing to DTMF.
NOTE: This applies only to calls made using Analog Line Card ports.